Dell Force10 C150 Configuration Manual page 258

Aggregate routes
FTOS provides multiple ways to aggregate routes in the BGP routing table. At least one specific route of
the aggregate must be in the routing table for the configured aggregate to become active.
Use the following command in the CONFIGURATION ROUTER BGP mode to aggregate routes.
Command Syntax
aggregate-address ip-address mask
[ advertise-map map-name] [ as-set ]
[ attribute-map map-name]
[ summary-only ] [ suppress-map
map-name]
AS_SET includes AS_PATH and community information from the routes included in the aggregated route.
show ip bgp
In the
aggregate contain an 's' in the first column.
Figure 10-30. Command Example: show ip bgp
FTOS#show ip bgp
BGP table version is 0, local router ID is 10.101.15.13
Status codes: s suppressed, d damped, h history, * valid, > best
Path source: I - internal, a - aggregate, c - confed-external, r - redistributed, n - network
Origin codes: i - IGP, e - EGP, ? - incomplete
Network
*> 7.0.0.0/29
*> 7.0.0.0/30
*>a 9.0.0.0/8
*> 9.2.0.0/16
*> 9.141.128.0/24
FTOS#
Configure BGP confederations
Another way to organize routers within an AS and reduce the mesh for IBGP peers is to configure BGP
confederations. As with route reflectors, BGP confederations are recommended only for IBGP peering
involving a large number of IBGP peering sessions per router. Basically, when you configure BGP
confederations, you break the AS into smaller sub-AS, and to those outside your network, the
confederations appear as one AS. Within the confederation sub-AS, the IBGP neighbors are fully meshed
and the MED, NEXT_HOP, and LOCAL_PREF attributes are maintained between confederations.
258 | Border Gateway Protocol IPv4 (BGPv4)
Command Mode
CONFIG-ROUTER-
BGP
command, aggregates contain an 'a' in the first column and routes suppressed by the
Next Hop Metric
10.114.8.33
10.114.8.33
192.0.0.0
Aggregate Route
10.114.8.33
Indicators
10.114.8.33
Purpose
Assign the IP address and mask of the prefix to be
aggregated.
Optional parameters are:
advertise-map
•
advertising an aggregate route
as-set : generate path attribute information and
•
include it in the aggregate.
attribute-map
•
aggregate, except for the AS_PATH and NEXT_HOP
attributes
summary-only
•
address. Specific routes will not be advertised
suppress-map
•
more-specific routes in the aggregate are suppressed
LocPrf Weight Path
0 0 18508 ?
0 0 18508 ?
32768 18508 701 {7018 2686 3786} ?
0 18508 701 i
0 18508 701 7018 2686 ?
:
map-name set filters for
map-name: modify attributes of the
:
advertise only the aggregate
map-name :
identify which