Dell Force10 C150 Configuration Manual page 524

Figure 23-8. Command Example:
FTOS#show isis database
IS-IS Level-1 Link State Database
LSPID
B233.00-00
eljefe.00-00
eljefe.01-00
eljefe.02-00
Force10.00-00
IS-IS Level-2 Link State Database
LSPID
B233.00-00
eljefe.00-00
eljefe.01-00
eljefe.02-00
Force10.00-00
FTOS#
Control routing updates
Use the following commands in ROUTER ISIS mode to control the source of IS-IS route information.
Command Syntax
passive-interface
524 | Intermediate System to Intermediate System
LSP Seq Num
0x00000003
* 0x00000009
* 0x00000001
* 0x00000001
0x00000002
LSP Seq Num
0x00000006
* 0x0000000D
* 0x00000001
* 0x00000001
0x00000004
Command Mode
ROUTER ISIS
interface
show isis database
LSP Checksum LSP Holdtime
0x07BF 1088
0xF76A 1126
0x68DF 1122
0x2E7F 1113
0xD1A7 1102
LSP Checksum LSP Holdtime
0xC38A 1124
0x51C6 1129
0x68DF 1122
0x2E7F 1113
0xCDA9 1107
Purpose
Disable a specific interface from sending or receiving
IS-IS routing information.
Enter the type of interface and slot/port information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port
information.
• For the Loopback interface on the RPM, enter the
keyword loopback followed by a number from 0 to
16383.
For a port channel, enter the keyword port-channel
•
followed by a number from 1 to 255 for TeraScale
and ExaScale, 1 to 32 for EtherScale.
For a SONET interface, enter the keyword sonet
•
followed by slot/port information.
• For a 10-Gigabit Ethernet interface, enter the
keyword TenGigabitEthernet followed by the slot/
port information.
For a VLAN, enter the keyword vlan followed by a
•
number from 1 to 4094.
E-Series ExaScale platforms support 4094
VLANs with FTOS version 8.2.1.0 and later.
Earlier ExaScale supports 2094 VLANS.
ATT/P/OL
0/0/0
0/0/0
0/0/0
0/0/0
0/0/0
ATT/P/OL
0/0/0
0/0/0
0/0/0
0/0/0
0/0/0