Dell Force10 C150 Configuration Manual page 239

Step Command Syntax
neighbor peer-group-name no
3
shutdown
neighbor peer-group-name
4
remote-as as-number
Only after the peer group responds to an OPEN message sent on the subnet does its BGP state change to
ESTABLISHED. Once the peer group is ESTABLISHED, the peer group is the same as any other peer
group.
For more information on peer groups, refer to
Maintain existing AS numbers during an AS migration
local-as
The feature smooths out the BGP network migration operation and allows you to maintain
existing ASNs during a BGP network migration.
When you complete your migration, be sure to reconfigure your routers with the new information and
disable this feature.
Command Syntax
neighbor
{IP address |
peer-group-name local-as
number [no prepend]
Disable this feature, using the
Command Mode
CONFIG-ROUTER-
BGP
CONFIG-ROUTER-
BGP
Command Mode
CONFIG-ROUTER-
as BGP
You must Configure Peer Groups
This feature is not supported on passive peer groups.
no neighbor local-as
Purpose
Enable the peer group.
Create and specify a remote peer as a BGP
neighbor.
Configure Peer Groups on page
Purpose
Allow external routes from this neighbor.
Format:
IP Address: A.B.C.D
Peer Group Name: 16 characters
AS-number: 0-65535 (2-Byte) or 1-4294967295 (4-Byte)
or
0.1-65535.65535 (Dotted format)
No Prepend specifies that local AS values are not
prepended to announcements from the neighbor.
before assigning it to an AS.
command in CONFIGURATION ROUTER BGP mode.
Border Gateway Protocol IPv4 (BGPv4) | 239
232.