Configuration Task List For Ipv6; Change Your Cam-Profile On An E-Series System - Dell Force10 C150 Configuration Manual

Configuration Task List for IPv6

This section contains information regarding the following:
•

Change your CAM-Profile on an E-Series system

• Adjust your CAM-Profile on an C-Series or S-Series
• Assign an IPv6 Address to an Interface
• Assign a Static IPv6 Route
• Telnet with IPv6
• SNMP over IPv6
• Show IPv6 Information
• Clear IPv6 Routes
Change your CAM-Profile on an E-Series system
The cam-profile command is supported only on platform
Change your CAM profile to the CAM
CAM profile is changed, save the configuration and reboot your router.
Command Syntax
cam-profile ipv6-extacl
microcode ipv6-extacl
| linecard slot
Figure 22-4
configured.
Memory, on page 281
Figure 22-4. Command Example:
FTOS#show cam-profile summary
-- Chassis CAM Profile --
Profile Name
MicroCode Name
-- Line card 1 --
Profile Name
MicroCode Name
FTOS#
496 | IPv6 Addressing
Command Mode
EXEC Privileged
chassis
displays the IPv6 CAM profile summary for a chassis that already has IPv6 CAM profile
Figure 22-5 shows the full IPv6 CAM profiles. Refer to
for complete information regarding CAM configuration.
: Current Settings : Next Boot
: IPV6-ExtACL
: IPv6-ExtACL
: Current Settings : Next Boot
: IPV6-ExtACL
: IPv6-ExtACL
(mandatory)
e
ipv6-extacl
before doing any further IPv6 configuration. Once the
Purpose
Enable the CAM profile with IPv6 extended ACLs
on the entire chassis or on a specific linecard
chassis
in the chassis
linecard slot/port changes the CAM profile only
for the specified slot
show cam-profile summary
: IPV6-ExtACL
: IPv6-ExtACL
: IPV6-ExtACL
: IPv6-ExtACL
changes the CAM profile for all linecards
Chapter 11, Content Addressable
(E-Series)