Monitoring Pim; Pim-Sm And Igmp Snooping: Usage Notes - Dell Force10 C150 Configuration Manual

To prevent these delivery errors you must statically map the potential incoming interfaces for the (*,G)
entries via the CLI. When you create this mapping, (*,G) entries are programmed in hardware. Packets are
then fast forwarded starting with the first packet, and the potential for these delivery errors is avoided.
Step Task
1
Create a standard access-list that
permits one or more IGMP groups.
FTOS(config-std-nacl)#show config
!
ip access-list standard map1
seq 5 permit 224.0.0.0/24
2 Apply the ACL to an interface on
which there might be a source for a
group specified in the ACL. This
command maps the incoming
interface to the (*,G) entry so that the
entry can be programmed into
hardware.

Monitoring PIM

The PIM MIB is supported only on platform
FTOS fully supports the PIM MIB as specified in RFC 5060 with some exceptions.
• The following tables are not supported:
• pimBidirDFElectionTable
• pimAnycastRPSetTable
• The OIDs related to InvalidRegisterMsgs reflect the last received invalid register message. Similarly,
the OIDs related to InvalidJoinPruneMsgs reflect the last received invalid Join or Prune message.
• OIDs which refer to any timer show the time that the timer started; it is 0 otherwise.

PIM-SM and IGMP Snooping: Usage Notes

PIM-SM is supported with IGMP snooping.
multicast traffic when you enable different combinations of PIM-SM DR flooding and IGMP snooping
flooding on a switch/router.
When you enable PIM-SM and IGMP snooping at the same time:
• The IGMP report is forwarded on the port that connects to the PIM DR.
• The port that connects to the PIM DR port and ports on which IGMP queries are received are chosen as
IGMP router ports. It is recommended that you configure the both the IGMP querier and the PIM DR
in the same router to avoid unnecessary flooding.
766 | PIM Sparse-Mode
Command Syntax
ip access-list standard name
ip pim ingress-interface-map std-access-lis
e
Figure 34-10 shows the egress ports used for outgoing
Command Mode
CONFIGURATION
t INTERFACE