Troubleshooting Frrp; Configuration Checks; Sample Configuration And Topology - Dell Force10 C150 Configuration Manual

Command Syntax
clear frrp
Show FRRP configuration
Use the following command to view the configuration for the FRRP group.
Command Syntax
show configuration
Show FRRP information
Use one of the following commands show general FRRP information.
Command Syntax
show frrp
ring-id
show frrp summary

Troubleshooting FRRP

Configuration Checks

• Each Control Ring must use a unique VLAN ID.
• Only two interfaces on a switch can be Members of the same Control VLAN.
• There can be only one Master node for any FRRP Group.
• FRRP can be configured on Layer 2 interfaces only.
• Spanning Tree (if enabled globally) must be disabled on both Primary and Secondary interfaces when
FRRP is enabled.
• When the interface ceases to be a part of any FRRP process, if Spanning Tree is enabled globally,
it must be enabled explicitly for the interface.
• The maximum number of rings allowed on a chassis is 255.

Sample Configuration and Topology

Command Mode Purpose
EXEC PRIVELEGED Clear the counters associated with all FRRP
groups
Command Mode Purpose
CONFIG-FRRP Show the configuration for this FRRP group
Command Mode Purpose
EXEC or EXEC Show the information for the identified FRRP
PRIVELEGED group.
Ring ID: 1-255
EXEC or EXEC Show the state of all FRRP groups.
PRIVELEGED Ring ID: 1-255
Force10 Resilient Ring Protocol | 345