Dns With Traceroute - Dell Force10 C150 Configuration Manual

Command Syntax
ip domain-list
name

DNS with traceroute

To configure your switch to perform DNS with traceroute, follow the steps below in the
CONFIGURATION mode.
Command Syntax
ip domain-lookup
ip name-server
[ ipv4-address2 ...
ipv6 name-server
[ ...
ipv6-address2
traceroute
[
host
]
ipv6-address
Figure 21-6
Figure 21-6. Traceroute command example
FTOS#traceroute www.force10networks.com
Translating "www.force10networks.com"...domain server (10.11.0.1) [OK]
Type Ctrl-C to abort.
------------------------------------------------------------------------------------------
Tracing the route to www.force10networks.com (10.11.84.18), 30 hops max, 40 byte packets
------------------------------------------------------------------------------------------
470 | IPv4 Addressing
Command Mode
CONFIGURATION
Command Mode
CONFIGURATION
ipv4-address CONFIGURATION
ipv4-address6 ]
ipv6-address
]
ipv6-address6
| CONFIGURATION
ipv4-address |
is an example output of DNS using the traceroute command.
Purpose
Configure names to complete unqualified host names.
Configure this command up to 6 times to specify a list of
possible domain names.
FTOS searches the domain names in the order they were
configured until a match is found or the list is exhausted.
Purpose
Enable dynamic resolution of host names.
Specify up to 6 IPv4 or IPv6 name servers. The order you
entered the servers determines the order of their use. You
may have IPv4 and IPv6 name servers configured at the
same time.
When you enter the traceroute command without
specifying an IP address (Extended Traceroute), you are
prompted for a target and source IP address, timeout in
seconds (default is 5), a probe count (default is 3),
minimum TTL (default is 1), maximum TTL (default is
30), and port number (default is 33434). To keep the
default setting for those parameters, press the ENTER key.