Dell Force10 C150 Configuration Manual page 343

Step Command Syntax
member-vlan vlan-id
5
{range}
no disable
6
Configure and add the Member VLANs
Control and Member VLANS are configured normally for Layer 2. Their status as Control or Member is
determined at the FRRP group commands. For complete information about configuring VLANS in Layer 2
mode, see Chapter 25, Layer
Be sure to follow these guidelines:
• All VLANS must be in Layer 2 mode.
• Control VLAN ports must be tagged. Member VLAN ports except the Primary/Secondary interface
can be tagged or untagged.
• The Control VLAN must be the same for all nodes on the ring.
Use the commands in the following sequence, on all of the Transit switches in the ring, to create the
Members VLANs for this FRRP group.
Step Command Syntax
interface vlan
1 vlan-id
tagged interface slot/
2
port {range}
Command Mode
CONFIG-FRRP
CONFIG-FRRP
2.
Command Mode
CONFIGURATION
CONFIG-INT-VLAN
Purpose
Identify the Member VLANs for this FRRP
group
VLAN-ID, Range: VLAN IDs for the ring's
Member VLANS.
Enable FRRP
Purpose
Create a VLAN with this ID number
VLAN ID: 1-4094
Tag the specified interface or range of interfaces
to this VLAN.
Interface:
• For a 10/100/1000 Ethernet interface, enter
the keyword keyword
followed by the slot/port information.
• For a Gigabit Ethernet interface, enter the
GigabitEthernet
keyword
slot/port information
• For a SONET interface, enter the keyword
sonet
followed by slot/port information.
• For a 10 Gigabit Ethernet interface, enter the
TenGigabitEthernet
keyword
the slot/port information.
Slot/Port, Range: Slot and Port ID for the
interface. Range is entered Slot/Port-Port.
Force10 Resilient Ring Protocol | 343
GigabitEthernet
followed by the
followed by