Specify A Default Gateway - Dell Force10 C150 Configuration Manual

To create an address pool:
Step Task
1 Access the DHCP server CLI context.
2 Create an address pool and give it a name.
3 Specify the range of IP addresses from which the
DHCP server may assign addresses.
•
network
•
prefix-length
used for the network portion of the address
you specify.
4 Display the current pool configuration.
Once an IP address is leased to a client, only that client may release the address. FTOS performs a IP +
MAC source address validation to ensure that no client can release another clients address. This is a default
behavior, and is separate from
Exclude Addresses from the Address Pool
The DHCP server assumes that all IP addresses in a DHCP address pool are available for assigning to
DHCP clients. You must specify the IP address that the DHCP server should not assign to clients.
Task
Exclude an address range from DHCP assignment. The
exclusion applies to all configured pools.
Specify an Address Lease Time
Task
Specify an address lease time for the addresses in
a pool.

Specify a Default Gateway

The IP address of the default router should be on the same subnet as the client.
Task
Specify default gateway(s) for the clients on the subnet, in
order of preference.
316 | Dynamic Host Configuration Protocol
is the subnet address.
specifies the number of bits
IP+MAC Source Address Validation on page
Command Syntax
ip dhcp server
pool name
network network /prefix-length
Prefix-length Range: 17-31
show config
Command Syntax
excluded-address
Command Syntax
lease days hours minutes
{ [ ] [
Default: 24 hours
Command Syntax
default-router address
Command Mode
CONFIGURATION
DHCP
DHCP <POOL>
DHCP <POOL>
328.
Command Mode
DHCP
Command Mode
infinite
] | } DHCP <POOL>
Command Mode
DHCP <POOL>