Dell Force10 C150 Configuration Manual page 867

In the following configuration, packets are classified to queues using the three class maps:
!
policy-map-input input-policy
service-queue 1 class-map qos-BE1
service-queue 3 class-map qos-AF3
service-queue 4 class-map qos-AF4
!
class-map match-any qos-AF3
match ip dscp 24
match ip access-group qos-AF3-ACL
!
class-map match-any qos-AF4
match ip dscp 32
match ip access-group qos-AF4-ACL
!
class-map match-all qos-BE1
match ip dscp 0
match ip access-group qos-BE1-ACL
The packet classification logic for the above configuration is as follows:
1. Match packets against match-any qos-AF4. If a match exists, queue the packet as AF4 in Queue 4, and
if no match exists, go to the next class map.
2. Match packets against match-any qos-AF3. If a match exists, queue the packet as AF3 in Queue 3, and
if no match exists, go to the next class map.
3. Match packets against match-all qos-BE1. If a match exists, queue the packet as BE1, and if no match
exists, queue the packets to the default queue, Queue 0.
You can optionally classify packets using their DSCP marking, instead of placing packets in Queue 0, if no
match occurs. In the above example, if no match occurs against match-all qos-BE1, the classification logic
continues:
4. Queue the packet according to the DSCP marking. The DSCP to Queue mapping will be as per the
Table 41-5.
The behavior is similar for
is according to Table
To enable Fall Back to trust diffserve or dot1p:
Task
Classify packets according to their DSCP value as a secondary
option in case no match occurs against the configured class
maps.
Mapping dot1p values to service queues
Mapping dot1p values to service queues
trust dot1p fallback
41-6.
is available only on platforms:
in a Layer2 input policy map; the dot1p-to-queue mapping
Command Syntax
trust diffserve | dot1p
{
fallback
Command Mode
}
POLICY-MAP-IN
c s
Quality of Service | 867