Set The Frequency Of Ftsa Type 3 Messages; Generate Ftsa Type 4 Messages; Set Parameters Ftsa Type 5 Messages - Dell Force10 C150 Configuration Manual

Set the Frequency of FTSA Type 3 Messages

When messaging is enabled, FTSA sends an E-mail every 24 hours containing inventory information to all
recipients. There is no facility for setting the frequency for individual recipients.
Task
Set the frequency at which FTSA generates
inventory E-mails.
Range: 2 to 10080 minutes
Default: 1440 minutes (24 hours)

Generate FTSA Type 4 Messages

FTSA can collect and E-mail a user-defined subset of the local system log.These E-mails are Type 4, and
Type 4 messages are enabled by default:
Step Task
1 Ensure that system logging is on,
and verify the logging severity
level.
2 Collect and E-mail system log
messages.
• If you do not use the
option, FTSA uses 7 by default.
• This is the recommended
severity level. Lower values
will result in partial log data
sent to the server because
messages with higher values
are filtered out.
After the initial message, subsequent messages only include log entries with that were generated after the
last message was sent to the server so that log messages are not repeated in multiple E-mails.

Set Parameters FTSA Type 5 Messages

FTSA Type 5 messages have two configurable parameters:
Task
Divert Type 5 messages to the internal flash
directory /CALL-HOME-LOGS instead of sending
them to FTSA recipients. Filenames include the
action list name and a timestamp, and use the file
extension .ftsa.
354 | Force10 Service Agent
Command
frequency
Command
logging on
do show running-config logging
log-messages [ delay minutes]
[ severity level] [ filter string]
severity
Command
log-only
Command Mode
CALLHOME
minutes
Command Mode
CONFIGURATION
CONFIGURATION<SERVER>
Command Mode
CALLHOME ACTIONLIST