Vrrp Version 3 - Dell Force10 C150 Configuration Manual

Ftos configuration guide ftos 8.4.2.7 e-series terascale, c-series, s-series (s50/s25)
Hide thumbs Also See for Force10 C150:
Table of Contents

Advertisement

Table 58-1. Recommended VRRP Advertise Intervals
Total VRRP Groups
Between 1000 and 1200
Between 1200 and 1500
Note: 1500 VRRP groups are supported in FTOS Release 6.3.1.0 and later.
The recommendations in
broadcasts, or STP before changing the advertisement interval. When the number of packets processed by
RP2/CP/FP processor increases or decreases based on the dynamics of the network, the advertisement
intervals in may increase or decrease accordingly.
CAUTION: Increasing the advertisement interval increases the VRRP Master dead interval, resulting in an
increased failover time for Master/Backup election. Take extra caution when increasing the advertisement
interval, as the increased dead interval may cause packets to be dropped during that switch-over time.

VRRP version 3

VRRP version 3 defines VRRP for IPv6. The
groups, and is similar to the
INTERFACE mode to a group-specific VRRP command sub-mode.
In the VRRP mode, all VRRP commands are supported for IPv4 and IPv6, except for
which is not supported for IPv6. Also, the following EXEC commands are different for IPv4 and IPv6:
clear:
IPv4:
IPv6:
debug:
IPv4:
IPv6:
show:
IPv4:
IPv6:
1130
|
Virtual Router Redundancy Protocol (VRRP)
Recommended Advertise Interval
E-Series
C-Series
7 seconds
7 seconds
8 seconds
8 seconds
Table 58-1
may vary depending on various factors like ARP broadcasts, IP
vrrp-group
command, which creates an IPv4 VRRP group and moves you from
clear counters vrrp
clear counters vrrp ipv6
debug vrrp
debug vrrp ipv6
show vrrp
show vrrp ipv6
E-Series
S-Series
ExaScale
7 seconds
512
8 seconds
512
vrrp-ipv6-group
command is used to create IPv6 VRRP
Groups/Interface
E-Series
TeraScale
C-Series
S-Series
255
100
255
120
authentication-type
100
120

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents