Viewing The Lldp Configuration; Viewing Information Advertised By Adjacent Lldp Agents - Dell Force10 C150 Configuration Manual

Viewing the LLDP Configuration

Display the LLDP configuration using the command
INTERFACE mode, as shown in
Figure 26-9. Viewing LLDP Global Configurations
R1(conf)#protocol lldp
R1(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
hello 10
no disable
R1(conf-lldp)#
Figure 26-10. Viewing LLDP Interface Configurations
R1(conf-lldp)#exit
R1(conf)#interface gigabitethernet 1/31
R1(conf-if-gi-1/31)#show config
!
interface GigabitEthernet 1/31
no ip address
switchport
no shutdown
R1(conf-if-gi-1/31)#protocol lldp
R1(conf-if-gi-1/31-lldp)#show config
!
protocol lldp
R1(conf-if-gi-1/31-lldp)#

Viewing Information Advertised by Adjacent LLDP Agents

Display brief information about adjacent devices using the command
Figure 26-11. Display all of the information that neighbors are advertising using the command
neighbors detail
Figure 26-11. Viewing Brief Information Advertised by Adjacent LLDP Agents
R1(conf-if-gi-1/31-lldp)#end
R1(conf-if-gi-1/31)#do show lldp neighbors
Loc PortID
-------------------------------------------------------------------------
Gi 1/21
Gi 1/31
594 | Link Layer Discovery Protocol
Figure 26-9
, as shown in Figure
Rem Host Name Rem Port Id
- GigabitEthernet 2/11
- GigabitEthernet 3/11
show config
and Figure 26-10, respectively
26-12.
in either CONFIGURATION or
show lldp neighbors
Rem Chassis Id
00:01:e8:06:95:3e
00:01:e8:09:c2:4a
, as shown in
show lldp