Dell Force10 C150 Configuration Manual page 422

Command Syntax
ip address
ip-address mask
You can only configure one (1) primary IP address per interface. You can configure up to 255 secondary IP
addresses on a single interface.
To view all interfaces to see with an IP address assigned, use the
EXEC mode
To view IP information on an interface in Layer 3 mode, use the
Privilege mode
Figure 20-7. Command Example:
FTOS>show ip int vlan 58
Vlan 58 is up, line protocol is up
Internet address is 1.1.49.1/24
Broadcast address is 1.1.49.255
Address determined by config file
MTU is 1554 bytes
Inbound
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
422 | Interfaces
[ secondary ]
(Figure 176).
(Figure 159).
access list is not set
Command Mode
INTERFACE
show ip interface
Purpose
Configure a primary IP address and mask on
the interface. The
ip-address
dotted-decimal format (A.B.C.D) and the
must be in slash format (/xx).
mask
Add the keyword secondary if the IP
address is the interface's backup IP address.
show ip interfaces brief
show ip interface
command in the EXEC
must be in
command in the