Write The Contents Of The Trace Buffer; Clear The Trace Buffer - Dell Force10 C150 Configuration Manual

Figure 61-10. show command-history Command Example
FTOS#show command-history
[12/5 10:57:8]: CMD-(CLI):service password-encryption
[12/5 10:57:12]: CMD-(CLI):hostname Force10
[12/5 10:57:12]: CMD-(CLI):ip telnet server enable
[12/5 10:57:12]: CMD-(CLI):line console 0
[12/5 10:57:12]: CMD-(CLI):line vty 0 9
[12/5 10:57:13]: CMD-(CLI):boot system rpm0 primary flash://FTOS-CB-1.1.1.2E2.bin

Write the contents of the trace buffer

The trace logs are saved to automatically but you can save the contents of a buffer manually via the CLI.
To manually write the contents of a trace buffer on CP to a file on the flash:
Step Task
1 Write the buffered trace log to flash.
To manually write the contents of a trace buffer on LP to a file on the flash:
Step Task
1 Write the buffered trace log to flash.

Clear the trace buffer

Clear the command history buffer using the command clear command-history from EXEC Privilege mode,
as shown in
Figure 61-11. Clearing the Command History
FTOS#show command-history 10
[12/3 15:40:17]: CMD-(CLI):[show config]by default from console
[12/3 15:40:22]: CMD-(CLI):[ping 10.11.80.201]by default from console
[12/3 15:40:46]: CMD-(CLI):[show interfaces managementethernet 0/0]by default from console
[12/3 15:40:49]: CMD-(CLI):[shutdown]by default from console
[12/3 15:40:59]: CMD-(CLI):[no shutdown]by default from console
[12/3 15:41:1]: CMD-(CLI):[interface managementethernet 0/0]by default from console
[12/3 15:41:2]: CMD-(CLI):[shutdown]by default from console
[12/3 15:41:7]: CMD-(CLI):[ping 10.11.80.201]by default from console
[12/3 21:45:46]: CMD-(CLI):[enable]by default from console
[12/3 21:47:18]: CMD-(CLI):[show command-history 10]by default from console
FTOS#clear command-history
FTOS#show command-history 10
[12/3 21:47:43]: CMD-(CLI):[show command-history 10]by default from console
FTOS#
1216 | E-Series TeraScale Debugging and Diagnostics
Figure 61-11.
Command Syntax
upload trace-log cp
hw-trace | sw-trace
Command Syntax
upload trace-log rp1 | rp2 | linecard
[
hw-trace sw-trace
[ | ]
Command
Mode
cmd-history |
[ EXEC Privilege
]
Command
Mode
] EXEC Privilege
number