Sample Configuration - Dell Force10 C150 Configuration Manual

Figure 37-12. Showing CAM PBR Configuration Example
FTOS(conf-if-gi-8/1)#do show cam pbr l 8 p0
TCP Flag: Bit 5 - URG, Bit 4 - ACK, Bit 3 - PSH, Bit 2 - RST, Bit 1 - SYN, Bit 0 - FIN
Cam Port VlanID Proto Tcp
Index
-----------------------------------------------------------------------------------------------------------------------
----------
06080 0 N/A
06081 0 N/A

Sample Configuration

The following configuration is an example for setting up a PBR. These are not comprehensive directions.
They are intended to give you a some guidance with typical configurations.
You can copy and paste from these examples to your CLI. Be sure you make the necessary changes to
support your own IP Addresses, Interfaces, Names, etc.
Figure 37-13
defined in this example, creates the following rules:
• description Route Gold traffic to the DS3.
• seq 5 redirect 10.99.99.254 ip 192.168.1.0/24 any
• " Redirect to next-hop router IP 10.99.99.254 any traffic originating in 192.168.1.0/24."
• seq 10 redirect 10.99.99.254 ip 192.168.2.0/24 any
• " Redirect to next-hop router IP 10.99.99.254 any traffic originating in 192.168.2.0/24."
• seq 15 permit ip any any
810 | Policy-based Routing
Src Dst SrcIp
Flag Port Port
IP 0x0 0 0 200.200.200.200
TCP 0x10 0 40 234.234.234.234 255.234.234.234
is a graphic illustration of the configuration shown in
DstIp
200.200.200.200 199.199.199.199
Non-Contiguous Bitmasks
222.222.222.222/24
Contiguous Bitmasks
Figure
Next-hop
MAC
199.199.199.199 N/A
00:00:00:00:0
37-14. The Redirect-List GOLD