Multicast Storm Control; Storm Control Show Commands - Dell Force10 C150 Configuration Manual

Task
On the E-Series, suppress unknown-unicast packets if
they exceed a user-defined limit.
On the C-Series and S-Series, unknown-unicast packets
on ingress if they exceed a user-defined limit.

Multicast Storm Control

Multicast Storm Control
Task
Suppress multicast packets if they exceed a user-defined
limit.

Storm Control Show Commands

show storm-control
The
Force10 platform. These show commands are accessed from within either the EXEC or EXEC
, and consist of the following three commands:
mode
• show storm-control broadcast
• show storm-control multicast
• show storm-control unknown-unicast
These show commands can be entered with or without the interface option. Without the interface option,
storm control configuration information for the entire Dell Force10 platform is displayed.
To display the storm control configuration of a particular interface, use the interface option along with the
interface-type keyword and the slot and port information.
The following is a list of the interface-type keywords:
Fastethernet
•
GigabitEthernet
•
TenGigabitEthernet
•
The following example uses the
configuration on a Gigabit Ethernet interface on port 11, in slot 11 of an E-
1046 | Broadcast Storm Control
is supported only on platforms:
commands display the current storm control configuration of the entire Dell
— for a fast Ethernet interface
— for a 1-Gigabit Ethernet interface
— for a 10-Gigabit Ethernet interface
show storm-control broadcast
Command Syntax
storm-control unknown-unicast
percentage partial-percentage
out
]
storm-control unknown-unicast
packets-per-second in
c s
Command Syntax
storm-control multicast
packets-per-second in
command to display the storm control
Command Mode
CONFIGURATION
in
[ |
CONFIGURATION
Command Mode
CONFIGURATION
Privilege
Series platform
.