Create A Rule For A Redirect-List - Dell Force10 C150 Configuration Manual

Create a Rule for a Redirect-list

Use the following command in CONFIGURATION REDIRECT-LIST mode to set the rules for the
redirect list. You can enter the command multiple times and create a sequence of redirect rules. Use the
nn redirect
version of the command to organize your rules
Command Syntax
seq {number} redirect
{ ip-address | sonet }
{ |
ip-protocol-number protocol-type
any host ip-address
{ source mask | |
any
{ |
destination mask
Figure 37-4 shows a step-by-step example of how to create a rule for a redirect list by configuring:
• IP address of the next-hop router in the forwarding route
• IP protocol number
• Source address with mask information
• Destination address with mask information.
Command
Mode
CONF-
REDIRECT-
LIST
[ ]}
bit
}
host ip-address
| }
Delete a rule with the no redirect command.
The redirect rule supports
Destination router IP address
.
Purpose
Configure a rule for the redirect list.
number is the number in sequence to initiate this
rule
ip-address is the Forwarding router's address
FORMAT: A.B.C.D
sonet is a sonet interface
FORMAT: sonet slot/port
ip-protocol-number or protocol-type is the type of
protocol to be redirected
FORMAT: 0-255 for IP protocol number, or
enter protocol type
source ip-address or any
Source's IP address
FORMAT: A.B.C.D/NN, or ANY or HOST IP
address
destination ip-address or any
is the Destination's IP address
FORMAT: A.B.C.D/NN, or ANY or HOST IP
address
Non-contiguous bitmasks for PBR
seq
or
host ip-address is the
or
host ip-address
in the
Policy-based Routing | 805