Change Bootflash-Image - Dell Force10 S4810P Reference Manual

Command Modes EXEC Privilege
Command History
Version 7.6.1.0
Version 7.5.1.0
E-Series

change bootflash-image

Change boot flash image from which to boot.
C-Series, E-Series
Syntax change bootflash-image {cp | linecard linecard-slot | rp}
Parameters
cp
linecard
slot
rp
Defaults Not configured
Command Modes EXEC Privilege
Command History
Version 7.5.1.0
E-Series
Usage A system message appears stating that the bootflash image has been changed. You must
Information reload the system before the system can switch to the new bootflash image.
68
• flash: (internal Flash) or any sub-directory
• slot0: (external Flash) or any sub-directory (C-Series and
E-Series only)
Introduced on S-Series
Introduced on C-Series
Original command
Enter the keyword cp to change the bootflash image on the control
processor on the RPM.
linecard- Enter the keyword linecard followed by the slot number to change
the bootflash image on a specific line card. The C-Series range is 0-7.
The E-Series range is 0 to 13 on the E1200, 0 on 6 on the E600, and 0 to
5 on the E300.
Enter the keyword rp to change the bootflash image on the RPM.
Introduced on C-Series
Original command