Understanding No And Default Forms Of Commands; Understanding Cli Error Messages - Cisco 3032 Software Configuration Manual

Understanding no and default Forms of Commands

Understanding no and default Forms of Commands
Almost every configuration command also has a no form. In general, use the no form to disable a feature
or function or reverse the action of a command. For example, the no shutdown interface configuration
command reverses the shutdown of an interface. Use the command without the keyword no to re-enable
a disabled feature or to enable a feature that is disabled by default.
Configuration commands can also have a default form. The default form of a command returns the
command setting to its default. Most commands are disabled by default, so the default form is the same
as the no form. However, some commands are enabled by default and have variables set to certain default
values. In these cases, the default command enables the command and sets variables to their default
values.

Understanding CLI Error Messages

Table 2-3
switch.
Table 2-3 Common CLI Error Messages
Error Message
% Ambiguous command:
"show con"
% Incomplete command.
% Invalid input detected
at '^' marker.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
2-4
lists some error messages that you might encounter while using the CLI to configure your
Meaning
You did not enter enough characters
for your switch to recognize the
command.
You did not enter all the keywords or
values required by this command.
You entered the command
incorrectly. The caret (^) marks the
point of the error.
Chapter 2
How to Get Help
Re-enter the command followed by a question mark (?)
with a space between the command and the question
mark.
The possible keywords that you can enter with the
command appear.
Re-enter the command followed by a question mark (?)
with a space between the command and the question
mark.
The possible keywords that you can enter with the
command appear.
Enter a question mark (?) to display all the commands
that are available in this command mode.
The possible keywords that you can enter with the
command appear.
Using the Command-Line Interface
OL-12247-04