Log Messages Displayed During The Transition From Pending Or Disabled State To Active State; Log Messages Displayed During The Transition From Active Or Pending State To Disabled State; Log Messages Displayed For Stateful Srp And Line Module Switchover When Ha Is Enabled - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SERVICE AVAILABILITY CONFIGURATION GUIDE 2010-10-08 Configuration Manual

JunosE 11.3.x Service Availability Configuration Guide

Log Messages Displayed During the Transition from Pending or Disabled State to Active State

Log Messages Displayed During the Transition from Active or Pending State to Disabled State

Log Messages Displayed for Stateful SRP and Line Module Switchover When HA Is Enabled

92
to the disabled state. For SRP modules, the system transitions to the pending state. The
following sample log messages are generated for SRP modules when the system
transitions from the active state to the pending state, and for line modules when the
system transitions from the active state to the disabled state:
WARNING 03/08/2005 11:49:21 ha: High Availability on the SRP is pending due to the
creation of an unsafe configuration
WARNING 03/08/2005 11:49:21 ha: High Availability on slots X, Y is disabled due to the
creation of an unsafe configuration
NOTE: At this point, the creation of an unsafe configuration on the SRP might not cause
high availability on the line modules to change to the disabled state and vice-versa.
The system transitions to the pending state if an unsupported application is configured
for SRP modules. For line modules, when an unsupported application is configured, the
system transitions to the disabled state. After the configuration of the unsupported
application is removed, the system moves from the pending or disabled state to the
active state. The following sample log messages are generated for SRP modules that
are configured for high availability when the system transfers from the pending state to
the active state, and for line modules when the system transfers from the disabled state
to the active state:
WARNING 03/08/2005 11:54:10 ha: High Availability on the SRP is active due to removal
of an unsafe configuration
WARNING 03/08/2005 11:54:10 ha: High Availability on cards in slot X, Y is active due to
removal of an unsafe configuration
From the active state, the system changes to the pending state if an unsupported
application is configured for SRP modules. From the active state, the system changes
to the disabled state for line modules if an unsupported application is configured or if
any other criterion is not satisfied for remaining in the active state. The following log
messages are generated for SRP modules and line modules that configured for high
availability when the system transfers from the pending state or the active state to the
disabled state:
WARNING 03/09/2005 12:41:40 ha: High Availability on the SRP is disabled. Please check
redundancy configuration and status
WARNING 03/09/2005 12:41:40 ha: High Availability on the cards in slot X, Y is disabled.
Please check redundancy configuration and status
The following log messages are displayed for SRP modules and line modules when
stateful switchover is enabled for those modules.
ERROR 12/15/2003 23:34:23 os (): Standby SRP has assumed the role of Active SRP (warm
restart)
ERROR 12/15/2003 23:34:23 os (): Secondary line card in slot X has assumed the role of
Primary line card in slot Y (warm restart)
Copyright © 2010, Juniper Networks, Inc.