Installing And Configuring The Symposium Standby Server Feature - Nortel Call Center Server Installation And Maintenance Manual

July 2007
Installing and configuring the Symposium
Standby Server feature
Introduction
To install and configure the Symposium Standby Server feature, perform the
following tasks in sequence. This section provides step-by-step instructions for
completing each task.
Step 1. Install Symposium Call Center Server 5.0 on the Active Server
1 Follow the procedures in Chapter 4, "Preparing the server for your
installation," to install the hardware.
2 Follow the procedures in Chapter 5, "Installing the server software," to
install the software.
Step 2. Configure the Active Server
1 Once you have completed step 14 in the procedure "To configure the
product software" on page 194, follow the instructions in this step to
configure the Active Server.
2 If you are configuring an existing Symposium Call Center Server as the
Active Server and you are not already logged on as NGenSys, make sure
you log on to the server as NGenSys. From the Windows Start menu,
choose Programs → Symposium Call Center Server → Server Setup
Installation and Maintenance Guide for Windows 2003
Using Symposium Standby Server
1223