Nortel Call Center Server Installation And Maintenance Manual page 1134

Using server utilities
When changing the IP address of a Symposium Call Center Server
If you change the IP address of a server in Symposium Call Center Server, it
impacts other applications that connect to the server, such as Symposium Web
Client. Therefore, when you change the IP address, you must notify the
Symposium Web Client administrator.
Additional steps required for servers in a networking environment
If you make changes to the ELAN, CLAN, or site name on either an NCC server
or a server that is connected to an NCC server for networking, you must perform
some additional steps after making the change in the Server Setup Configuration
utility.
If you change the CLAN
or site name of an NCC
server
If you change the CLAN,
ELAN, or site name of a
nodal server connected to
an NCC server
For more information, refer to the Network Control Center Administrator's
Guide (see the section titled "Configuring the communications database").
1134
Using the Configuration (nbconfig) utility on the
NCC server, add all of the sites in your multi-site
call center. This updates the servers in the network
with the changed information from the NCC.
Using the Configuration (nbconfig) utility on the
NCC server, remove and then re-add the changed
nodal server. This updates the servers in the network
with the changed information from the nodal server.
Standard 7.02
Symposium Call Center Server