Nortel Call Center Server Installation And Maintenance Manual page 1218

Using Symposium Standby Server
Hardware
item Minimum
Serial ports 1 serial port (for
modem access) or
USB Port (if using
USB Modem)
Parallel port Not required
Network 1 network interface
interface card
Video card 1 video card and
monitor
Mouse 1 mouse
1218
Recommended
1 serial port (for
modem access) or
USB Port (if using
USB Modem)
Not required
1 network interface
card
1 video card and
monitor
1 mouse
Notes
optional serial ports, as follows:
If you are using a modem for
remote support, rather than a
virtual private network (VPN),
you require one serial port,
configured as COM1. If you
are using a USB modem, you
require a USB port.
If you use a smart UPS that
requires an additional serial
port on the server platform,
you also need the additional
serial port.
Note: For COM1, set the base
I/O Port Address to 3F8 and the
IRQ to 4.
CLAN should be 100Mbps
(Ethernet)
If you have more than one
network interface card, you must
configure the bindings order of
the network interface cards so
that the Nortel server (CLAN)
subnet card is first, then the
virtual adapters for remote
access.
800x600 minimum resolution
Symposium Call Center Server
Standard 7.02