Nortel Call Center Server Installation And Maintenance Manual page 1160

Installing and configuring Real-time Statistics Multicast
[MCast]
IP=234.5.6.7
Port=6040
ATTENTION
5 Save the mRcv.ini file. After setting the parameters for your test, you can
start mRcv.exe to begin the test. See "To start the mRcv application" on
page 1161 for more information.
Sample mRcv.ini file
The sample below is the default mRcv.ini file provided by the Symposium Call
Center Server installation. If you run the mRcv.exe utility using this .ini file, it
will display Skillset - Moving window data sent by RSM, based on the settings
in the [MCast] section at the bottom of the file (IP = 234.5.6.7 Port = 6050).
Note: The list of port numbers in the mRcv.ini file is for reference only, and each
line is "commented out" with the # symbol. You can use these port numbers as
an easy-to-access list of valid ports that are being used in the system to display
data. The only portion of the .ini file that can be modified is the [MCast] section
at the bottom of the file.
#######################################################
# mRcv.ini file
#
# Valid port numbers are:
# Application - Interval to date = 6020
# Application - Moving window = 6030
# Skillset - Interval to date = 6040
# Skillset - Moving window = 6050
# Agent - Interval to date = 6060
# Agent - Moving window = 6070
# Nodal - Interval to date = 6080
# Nodal - Moving window = 6090
# IVR - Interval to date = 6100
# IVR - Moving window = 6110
# Route - Interval to date = 6120
# Route - Moving window = 6130
1160
The IP= value must match your IP multicast address.
Standard 7.02
Symposium Call Center Server