Nortel Call Center Server Installation And Maintenance Manual page 1273

July 2007
Click OK if you have already done this; otherwise, shut down and
5
disconnect the Active Server before clicking OK. If you do not want to
continue, click Cancel on the message box.
Result: The Warm Standby configuration on the Replication Server
changes the Standby Server to the Active Server. A message appears
prompting you to configure the Standby Server as the Active Server.
To configure the Standby Server as the Active Server
Note: For DMS/SL-100 systems, make sure you move the iButton and dongle
(iButton USB or parallel port holder) from the Active Server to the Standby
Server before configuring the Standby Server as the Active Server.
1 If your Active and Standby servers are on a domain, remove the Active and
Standby servers from the domain (domain administrator privileges
required). If you do not have domain administrator privileges, have the
domain administrator remove your Active and Standby server from the
Active Directory Users and Computers.
Using My Computer → Properties, change the computer name to the Active
2
Host Name
Restart the server.
3
4 If your Active and Standby servers are on a domain, add the Active server
to the domain.
Using Start → Programs → Symposium Call Center Server → Computer
5
Name Sync, synchronize the Symposium Call Center Server name with the
new computer name.
Restart the server.
6
Installation and Maintenance Guide for Windows 2003
Using Symposium Standby Server
1273