E5@J Temperature Controller Protocol - Omron CQM1H-SCB41 Operation Manual

Sysmac cqm1h series serial communications board
Hide thumbs Also See for CQM1H-SCB41:
Table of Contents

Advertisement

E5@J Temperature Controller Protocol

The E5@J Temperature Controller Protocol performs various settings and controls in remote mode for the Tem-
perature Controller connected to the Serial Communications Board via RS-232C or RS-422A/485 cable.
Note Negative values cannot be written. All values must be set as unsigned BCD.
Structure of the Protocol
The following table shows the structure of the E5@J Temperature Controller Protocol.
Sequence
Communications
No.
sequence name
200
Select remote mode
201
Select local mode
202
Select backup mode
203
Select RAM write mode Switches from set point write mode to RAM
204
Save set point
205
Write parameters 1
206
Write parameters 2
207
Write input shift value
208
Read parameters 1
209
Read parameters 2
210
Read input shift value
211
Read output value
212
Read process value
213
Read set point limit
214
Read heater current
215
Read initial status
216
General-purpose write
217
General-purpose read
Note Ladder Interface Settings
YES:
User settings are required for the 2nd or 3rd operands of PMCR.
NO:
Send word allocation:
Receive word allocation: Set a dummy word (e.g., DM 0000) address for the 3rd operand (D).
Appendix G
Function
Switches the Controller to remote mode.
Switches the Controller to local mode.
Switches from set point write mode to backup
mode.
write mode.
Saves the set point.
Writes the set point, alarm value 1, alarm
value 2, and heater burnout alarm value.
Writes the proportional band, integral time,
and derivative time.
Writes the input shift value.
Reads the set point, alarm value 1, alarm
value 2, and heater burnout alarm value.
Reads the proportional band, integral time,
and derivative time.
Reads the input shift value and writes it in
IOM.
Reads the output value and stores it in IOM.
Reads the process value and stores it in IOM.
Reads the set point limits and stores them in
IOM.
Reads the heater current and stores it in IOM.
Reads the initial status and stores it in IOM.
Writes the specified parameter by setting a
header code.
Reads the specified parameter by setting a
header code.
Set the constant 0000 for the 2nd operand (S).
Ladder interface
Send word
Receive word
allocation
allocation
Yes
No
Yes
No
Yes
No
Yes
No
Yes
No
Yes
No
Yes
No
Yes
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
Yes
Yes
231

Advertisement

Table of Contents
loading

Table of Contents