Omron CQM1H-SCB41 Operation Manual page 352

3Z4L Laser Micrometer Protocol
Receive Data Word Allocation (3rd Operand of PMCR)
None.
Note 1. Memory switches cannot be set when DIP switch SW3, pin 5 of the Laser Micrometer is not turned
ON.
2. The setting (y, z) of RS-232C takes effect when the power supply is turned back on.
Memory Switch Set 2 (3000-series, High-speed Type)
(Sequence No. 422)
This sequence sets memory switches.
Send Data Word Allocation (2nd Operand of PMCR)
First word of send
data
Receive Data Word Allocation (3rd Operand of PMCR)
None.
Note Memory switches cannot be set when DIP switch SW3, pin 5 of the Laser Micrometer is not turned ON.
Simple AVG Times Set (3000-series, High-speed Type)
(Sequence No. 423)
This sequence uses the simple average as the averaging method and sets the averaging times per measure-
ment interval 4.
Send Data Word Allocation (2nd Operand of PMCR)
First word of send
data
Receive Data Word Allocation (3rd Operand of PMCR)
None.
+0 Number of send data words
+1
W X Y
(Undefined)
+2
Offset Contents (data format)
+0 Number of send data words
(4 digits BCD)
+1 w (1 digit BCD)
x (1 digit BCD)
y (1 digit BCD)
z (1 digit BCD)
+2 v (1 digit BCD)
Note Settings marked with asterisks are required for this protocol.
+0
Number of send data words
Number of averaging times
+1
Offset Contents (data format)
+0 Number of send data words
(4 digits BCD)
+1 Number of averaging times
(4 digits BCD)
Z
V
0003 (fixed)
0: Work automatic detection is not performed
1: Work automatic detection is performed
Diameter detection method (1 scan)
2: Work automatic detection is performed
Diameter detection method (8 scan)
3: Work automatic detection is performed
Position detection method (1 scan)
For expansion
0 (fixed)
For expansion
0 (fixed)
For expansion
0 (fixed)
*0:Error data exclusion function is not used
1:Error data exclusion function is used
0002 (fixed)
1 to 2048
Appendix K
Data
Data
337