Output Commands; Output[<N>]:Idle - Rigol DG800 Pro Series Programming Manual

Command System
Examples
:MMEMory:STORe:STATe INT:\state.sta
in the file named state.sta under C disk.*/
3.10

:OUTPut Commands

:OUTPut commands are used to set and query the channel outputs.
TIP
As DG821 Pro has only one channel, it only supports CH1 parameter settings (unless the two-
channel upgrade option is installed).
3.10.1 :OUTPut[<n>]:IDLE
Syntax
:OUTPut[<
:OUTPut[<
Description
Sets or queries the idle level position of the burst mode for the specified channel.
Parameter
Name
<n>
<idle>
<position>
Remarks
• The parameter <idle> is used to self-define the idle level position and
<position> allows you to set the position to the first point (FPT), the top (TOP),
the center (CENTer), or the bottom (BOTTom) of the waveform.
• When [<n>] is omitted, it is interpreted as CH1.
Return Format
The query returns FPT, TOP, CENT, or BOTT; or returns the idle level position in an
integer.
Examples
:OUTPut1:IDLE TOP /*Sets the idle level to the top point of the
waveform.*/
DG800 Pro/DG900 Pro Programming
Guide
54
n >]:IDLE {< idle >|< position >}
n >]:IDLE?
Type
Discrete
Integer
Discrete
/*Stores the instrument state
Range
{1|2}
0 to 65535
{FPT|TOP|CENTer|BOTTom}
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Default
1
-
FPT