Trigger<N>:Delay - Rigol DG800 Pro Series Programming Manual

Command System
Remarks
• Trigger count is used to set the number of cycles of the effective output signals
after each trigger event. After the trigger count is complete, the trigger system
enters the idle state.
• It is only available for remote mode.
• The trigger count is valid only when
Return Format
The query returns an integer.
Examples
:TRIGger1:COUNt 100 /*Sets the trigger count to 100.*/
:TRIGger1:COUNt? /*Queries the trigger count. The query returns
100.*/
3.13.2 :TRIGger<n>:DELay
Syntax
:TRIGger<
:TRIGger<
Description
Sets or queries the trigger delay for the specified channel.
Parameter
Name
<n>
<seconds>
<lim_set>
<lim_query>
Remarks
Trigger delay is only available for N-Cycle burst mode. The range of <seconds> is
related to the burst trigger source:
• Manual/external trigger: 0 s to 20 s.
• Internal trigger: 0 s to (
greater than 20 s.
-
DG800 Pro/DG900 Pro Programming
Guide
184
n >:DELay {< seconds >|< lim_set >}
n >:DELay? [< lim_query >]
Type
Discrete
Real
Discrete
Discrete
T
burst
T
: burst period
burst
:INITiate[<n>]:CONTinuous
Range
{1|2}
Remarks
Refer to
{MINimum|MAXimum|DEFault}
{MINimum|MAXimum}
T
-⌈ ×N ÷6.4 ns⌉×6.4 ns -4 μs)
wave
cycle
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
is set to 0|OFF.
Default
1
0 s
-
-
[1]
, and no