Command System
•
The Track function is disabled when the Sequence mode, Counter, or front port
sync output is enabled.
•
When [:SOURce[<n>]] or [<n>] is omitted, it is interpreted as CH1.
Return Format
The query returns ON, OFF, or INV.
Examples
:SOURce1:TRACk ON /*Enables the channel track function for CH1.*/
:SOURce1:TRACk? /*Queries the channel track function for CH1. The
query returns ON.*/
3.11.20
[:SOURce[<n>]]:VOLTage
[:SOURce[<n>]]:VOLTage commands are used to set and query the on/off status of
amplitude coupling function, specify the waveform amplitude, waveform high/low
level, waveform offset voltage, and amplitude unit for the specified channel.
3.11.20.1
[:SOURce[<n>]]:VOLTage
Syntax
[:SOURce[<
[:SOURce[<
Description
Sets or queries the output amplitude for the specified channel.
Parameter
Name
<n>
<amplitude>
<lim_set>
<lim_query>
Remarks
•
The maximum value of <amplitude> is limited by the impedance
:OUTPut[<n>]:LOAD
(
refer to
Vpp
•
When [:SOURce[<n>]] or [<n>] is omitted, it is interpreted as CH1.
DG800 Pro/DG900 Pro Programming
Guide
158
n >]]:VOLTage {< amplitude >|< lim_set >}
n >]]:VOLTage? [< lim_query >]
Type
Discrete
Real
Discrete
Discrete
) and frequency (
Table 3.62 Range of Amplitude
: max. output amplitude ≤ (Vpp
max
Range
{1|2}
Refer to
Remarks
{MINimum|MAXimum|DEFault}
{MINimum|MAXimum}
[:SOURce[<n>]]:FREQuency
. Define the amplitude upper limit to
- 2*|V
|).
max
offset
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Default
1
5 Vpp
-
-
). For details,