Source[<N>]]:Fm; Source[<N>]]:Fm[:Deviation] - Rigol DG800 Pro Series Programming Manual

Parameter
Name
<n>
<bool>
Remarks
• After the burst mode is enabled, the modulation, sweep, or sequence mode (if
enabled currently) will be disabled automatically.
• The Burst mode cannot be enabled when the basic waveform frequency is less
than or equal to 125 μHz.
• When [:SOURce[<n>]] or [<n>] is omitted, it is interpreted as CH1.
Return Format
The query returns 0 or 1.
Examples
:SOURce1:BURSt:STATe ON /*Enables the burst mode for CH1.*/
:SOURce1:BURSt:STATe? /*Queries whether the burst mode is enabled
for CH1. The query returns 1.*/
3.11.5 [:SOURce[<n>]]:FM
[:SOURce[<n>]]:FM commands are used to set and query the FM parameters such as
the frequency deviation, modulating waveform frequency, modulation source,
modulating waveform, and the on/off status of the FM modulation.
3.11.5.1 [:SOURce[<n>]]:FM[:DEViation]
Syntax
[:SOURce[<
[:SOURce[<
Description
Sets or queries the FM frequency deviation for the specified channel.
Parameter
Name
<n>
<deviation>
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Type Range
Discrete {1|2}
Bool {0|1|OFF|ON}
n >]]:FM[:DEViation] {< deviation >|< lim_set >}
n >]]:FM[:DEViation]? [< lim_query >]
Type Range
Discrete {1|2}
Real Refer to
Remarks
DG800 Pro/DG900 Pro Programming
Command System
Default
1
0|OFF
Default
1
100 Hz
Guide
85