Trigger Output Connector - Rigol DHO900 User Manual

Triggering the Oscilloscope
the level of CLK. For details, refer to descriptions in
trigger level is displayed in the trigger information label at the top of the screen.
• Level B
Click or tap the input field of Level B to input the level of MISO with the pop-up
numeric keypad. You can also use the corresponding multipurpose knob to
adjust the level of MISO. When the level B information is displayed in the trigger
label, you can also use the trigger level knob to adjust the level of MISO. For
details, refer to descriptions in
in the trigger information label at the top of the screen.
• Level C
Click or tap the input field of Level C to input the level of CS with the pop-up
numeric keypad. You can also use the corresponding multipurpose knob to
adjust the level of CS. When the level C information is displayed in the trigger
label, you can also use the trigger level knob to adjust the level of CS. For details,
refer to descriptions in
trigger information label at the top of the screen.
8.8

Trigger Output Connector

The rear-panel trigger output connector ([AUX OUT]) of this series can output trigger
signals determined by the current setting (hardware trigger).
Click or tap
signal which reflects the current oscilloscope capture rate can be output from [AUX
OUT] connector each time a trigger is generated by the oscilloscope. If this signal is
connected to a waveform display device to measure the frequency, the measurement
result is the same as the current capture rate.
If "PassFail" is selected in Aux Out, the instrument can output a pulse from the [AUX
OUT] connector when a pass/failed event is detected during the pass/fail test.
DHO800 User Guide
104
Trigger Level
Trigger Level
> Utility. Click or tap Setup, and then select "TrigOut" in Aux Out. A
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Trigger Level
. The current trigger level is displayed
. The current trigger level is displayed in the
. The current