Source[<N>]]:Phase:synchronize - Rigol DG800 Pro Series Programming Manual

Command System
• When the coupling mode is set to "ratio", if the frequency, amplitude, or phase
of either channel exceeds the upper/lower limit after calculation according to
the coupling rules due to modifying the coupling ratio, switching waveform, or
changing waveform parameters, the generator will automatically adjust the
waveform parameters to avoid parameter overlimit.
• When the coupling mode is set to "deviation", if the frequency, amplitude or
phase of either channel exceeds the upper/lower limit after calculation
according to the coupling rules due to modifying the coupling deviation, the
generator will automatically adjust the coupling deviation to avoid parameter
overlimit; if it is due to switching waveform or changing waveform parameters,
the corresponding coupling function is disabled.
• The phase coupling function is available only when the output modes of both
channels are set to Continuous and the output waveform is set to Sine, Square,
or Ramp.
• When [:SOURce[<n>]] or [<n>] is omitted, it is interpreted as CH1.
Return Format
The query returns 0 or 1.
Examples
:SOURce1:PHASe:COUPle:STATe ON /*Enables the phase coupling
function for CH1.*/
:SOURce1:PHASe:COUPle:STATe? /*Queries the on/off status of the
phase coupling function for CH1. The query returns 1.*/
3.11.12.6 [:SOURce[<n>]]:PHASe:SYNChronize
Syntax
[:SOURce[<
Description
Performs an align phase operation.
Parameter
Name
<n>
Remarks
• The align phase function is only available for the Continuous mode as well as
the internally triggered Burst and Sweep modes.
• The align phase function is not available for DG821 Pro (unless the two-channel
upgrade option is installed).
DG800 Pro/DG900 Pro Programming
Guide
130
n >]]:PHASe:SYNChronize
Type Range
Discrete {1|2}
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Default
1