Source[<N>]]:Apply:sinusoid - Rigol DG800 Pro Series Programming Manual

Command System
Remarks
• The range of <frequency> is related to the instrument model (
of Continuous Waveform Frequency
Table 3.62 Range of Amplitude
amplitude setting.
• Executing this command will overwrite the current symmetry setting
[:SOURce[<n>]]:FUNCtion:RAMP:SYMMetry
(
ramp.
• When [:SOURce[<n>]] or [<n>] is omitted, it is interpreted as CH1.
Return Format
None.
Examples
:SOURce1:APPLy:RAMP 100,1,2,3 /*Sets CH1 to output a ramp with 100
Hz frequency, 1 Vpp amplitude, 2 Vdc offset, and 3° start phase.*/
3.11.2.7 [:SOURce[<n>]]:APPLy:SINusoid
Syntax
[:SOURce[<
< lim_set >}[,{< offset >|< lim_set >}[,{< phase >|< lim_set >}]]]]
Description
Sets the specified channel to output a sine wave with the specified frequency,
amplitude, offset, and phase.
Parameter
Name
<n>
<lim_set>
<frequency>
<amplitude>
<offset>
<phase>
DG800 Pro/DG900 Pro Programming
Guide
74
n >]]:APPLy:SINusoid [{< frequency >|< lim_set >}[,{< amplitude >|
Type Range
Discrete {1|2}
Discrete {DEFault|MINimum|MAXimum}
Real Refer to
Real Refer to
Real Refer to
Real -360° to 360°
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
). For the range of <amplitude>, refer to
. The range of <offset> is limited by the current
) and set 50% symmetry for the
Remarks
Remarks
Remarks
Table 3.60 Range
Default
1
-
1 kHz
5 Vpp
0 Vdc
0°