Counter:single - Rigol DG800 Pro Series Programming Manual

Description
Sets or queries the operating status of the frequency counter.
Parameter
Name
<state>
Remarks
• RUN: sets the counter operating status to "Run". In this mode, the instrument
measures the input signal continuously according to the current configuration.
When the counter is enabled, the default setting is "Run".
• STOP: sets the counter operating status to "Stop". In this mode, the instrument
stops the measurements after finishing the current measurement.
Return Format
The query returns RUN or STOP.
Examples
:COUNter:RUN:STATe RUN /*Sets the operating status of the frequency
counter to Run.*/
:COUNter:RUN:STATe? /*Queries the operating status of the frequency
counter. The query returns RUN.*/
3.2.12

:COUNter:SINGle

Syntax
:COUNter:SINGle
Description
Sets single measurement for the frequency counter.
Parameter
None.
Remarks
Send this command and then the instrument enters the "single" measurement state.
That is, the instrument executes a single measurement and then enters the "Stop"
state. This command is available only when the frequency counter (
is enabled.
Return Format
None.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Type Range
Discrete {RUN|STOP}
Command System
Default
RUN
:COUNter[:STATe]
DG800 Pro/DG900 Pro Programming
)
Guide
15