Command System; Abort; Table 3.1 Unit Description - Rigol DG800 Pro Series Programming Manual

3

Command System

This chapter introduces the syntax, functions, parameters, and usage of each DG800
Pro/DG900 Pro command.
For the parameter setting command (frequency, amplitude, offset, high level, low
level, time), the instrument can recognize the unit. If omitted, it is interpreted as the
default unit. For the default units of parameters, see the table below.

Table 3.1 Unit Description

Parameter
Frequency
Amplitude
Offset/High Level/Low
Level
Time
NOTE
Since the SCPI parser is case-insensitive, there is some confusion over the letter "M" (or "m").
For your convenience, this instrument interprets "mV" (or "MV") as millivolts and "ms" (or
"Ms") as milliseconds. However, it interprets "MHZ" (or "mhz") as megahertz.
3.1

:ABORt

Syntax
:ABORt
Description
Stops any operation that is triggered.
Parameter
None.
Remarks
None.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Available Units
MHZ, KHZ, HZ, UHZ
VPP, MVPP, VRMS, MVRMS,
DBM
V, MV
KS, S, MS, US, NS
Command System
Default Unit
HZ
VPP, VRMS, or DBM
(related to the current
amplitude unit)
V
S
DG800 Pro/DG900 Pro Programming
Guide
7