Source[<N>]]:Pm; Source[<N>]]:Pm:deviation - Rigol DG800 Pro Series Programming Manual

• When [:SOURce[<n>]] or [<n>] is omitted, it is interpreted as CH1.
Return Format
None.
Examples
:SOURce1:PHASe:SYNChronize /*Performs an align phase operation.*/
3.11.13 [:SOURce[<n>]]:PM
[:SOURce[<n>]]:PM commands are used to set and query the PM parameters such
as the phase deviation, modulating waveform frequency, modulation source,
modulating waveform, and the on/off status of the PM modulation.
3.11.13.1 [:SOURce[<n>]]:PM:DEViation
Syntax
[:SOURce[<
[:SOURce[<
Description
Sets or queries the PM phase deviation for the specified channel.
Parameter
Name
<n>
<deviation>
<lim_set>
<lim_query>
Remarks
• Phase deviation represents the peak variation in phase of the modulated
waveform from the carrier waveform.
• When an external modulation source (
the phase deviation is controlled by the signal from the real-panel [AUX IN/
OUT] connector.
• When [:SOURce[<n>]] or [<n>] is omitted, it is interpreted as CH1.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
n >]]:PM:DEViation {< deviation >|< lim_set >}
n >]]:PM:DEViation? [< lim_query >]
Type Range
Discrete {1|2}
Real 0° to 360°
Discrete {MINimum|MAXimum|DEFault}
Discrete {MINimum|MAXimum}
[:SOURce[<n>]]:PM:SOURce
DG800 Pro/DG900 Pro Programming
Command System
Default
1
90°
-
-
) is selected,
Guide
131