Source[<N>]]:Frequency - Rigol DG800 Pro Series Programming Manual

Command System
Return Format
The query returns 1 or 0.
Examples
:SOURce1:FM:STATe ON /*Enables the FM modulation function for
CH1.*/
:SOURce1:FM:STATe? /*Queries the on/off status of the FM
modulation function for CH1. The query returns 1.*/
3.11.6 [:SOURce[<n>]]:FREQuency
[:SOURce[<n>]]:FREQuency commands are used to set the instrument's output
frequency and dual-channel coupling mode.
3.11.6.1 [:SOURce[<n>]]:FREQuency
Syntax
[:SOURce[<
[:SOURce[<
Description
Sets or queries the frequency of the continuous waveform for the specified channel.
Parameter
Name
<n>
<frequency>
<lim_set>
<lim_query>
Remarks
• The available frequency range varies for different waveforms. For this, refer to
Table 3.60 Range of Continuous Waveform Frequency
• When the wave type of the specified channel is changed, the instrument still
uses the frequency if the frequency is valid. Otherwise, the instrument
automatically sets the frequency as the upper limit for the new wave type.
• When [:SOURce[<n>]] or [<n>] is omitted, it is interpreted as CH1.
DG800 Pro/DG900 Pro Programming
Guide
90
n >]]:FREQuency {< frequency >|< lim_set >}
n >]]:FREQuency? [< lim_query >]
Type Range
Discrete {1|2}
Real Refer to
Discrete {MINimum|MAXimum|DEFault}
Discrete {MINimum|MAXimum}
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Remarks
.
Default
1
1 kHz
-
-