Trigger<N>:Timer - Rigol DG800 Pro Series Programming Manual

Parameter
Name
<n>
<source>
Description
• This command is only available for the Burst mode or Sweep mode.
• IMMediate: immediate trigger. The frequency of N-Cycle bursts is determined
by the "Burst Period" (
of the sweep waveforms is determined by the specified sweep time
( [:SOURce[<n>]]:SWEep:TIME
hold time (
[:SOURce[<n>]]:SWEep:HTIMe[:STOP]
(
• EXTernal: external trigger. The instrument receives the trigger signal from the
rear-panel [AUX IN/OUT] connector. A burst/sweep output is generated each
time a TTL pulse with the specified polarity is received. You can specify the edge
type (
• BUS: manual/bus trigger. Sending
burst or sweep output immediately in the corresponding channel. If the output
of the corresponding channel is not enabled, the trigger will be ignored.
• TIMer: timer trigger. In Burst mode, the trigger event is determined by the timer
:TRIGger<n>:TIMer
(
for-trigger state. It is only available for remote mode.
Return Format
The query returns IMM, EXT, TIM, or BUS.
Examples
:TRIGger2:SOURce EXTernal /*Sets the trigger source to external for
CH2.*/
:TRIGger2:SOURce? /*Queries the trigger source for CH2. The query
returns EXT.*/
3.13.6 :TRIGger<n>:TIMer
Syntax
:TRIGger<
:TRIGger<
Description
Sets or queries the trigger timer for the specified channel.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Type
Discrete
Discrete
[:SOURce[<n>]]:BURSt:INTernal:PERiod
[:SOURce[<n>]]:SWEep:HTIMe:STARt
:TRIGger<n>:SLOPe
) for trigger input signal.
). The trigger occurs when the instrument is in the waiting-
n >:TIMer {< timer >|< lim >}
n >:TIMer? [< lim >]
Range
{1|2}
{IMMediate|EXTernal|BUS|TIMer} IMMediate
), return time ( [:SOURce[<n>]]:SWEep:RTIMe
), and stop hold time
).
*TRG :TRIGger[<n>][:IMMediate]
or
DG800 Pro/DG900 Pro Programming
Command System
Default
1
). The trigger period
), start
initiates a
Guide
187