To Output Sine Wave; Table 5.1 Range Of Continuous Waveform Frequency; Table 5.2 Range Of Amplitude - Rigol DG900 Pro Series User Manual

Continuous

Table 5.1 Range of Continuous Waveform Frequency

Waveform
Sine
Square
Triangle
Pulse
Standard Arb
Harmonic

Table 5.2 Range of Amplitude

Frequency
[1 μHz, 50 MHz]
(50 MHz, 100 MHz]
(100 MHz, 200 MHz]
5.1

To Output Sine Wave

You can configure the instrument to output sine wave in the following ways.
• In the Continuous Setting Interface (
drop-down button to select "Sine".
• In the Continuous Setting Interface (
Preview/Selection" area and then select Sine in the displayed built-in waveform
selection menu.
• Press the front-panel
In the setting interface for Sine wave, you can set the following parameters to create
different sine waves as desired.
Frequency/Period
Click or tap the Freq/Period button to set the parameter to "Freq". "Freq" is now
highlighted. Click or tap its input field and use the pop-up numeric keypad to set the
frequency for sine wave. By default, the frequency for sine wave is 1 kHz, and the
resolution is 1 μHz. For available ranges of the sine frequency of different models,
DG900 Pro User Guide
30
DG902 Pro DG912 Pro
1 μHz to 70 MHz 1 μHz to 150 MHz
1 μHz to 60 MHz 1 μHz to 60 MHz
1 μHz to 3 MHz 1 μHz to 5 MHz
1 μHz to 50 MHz 1 μHz to 50 MHz
1 μHz to 30 MHz 1 μHz to 50 MHz
1 mHz to 35 MHz 1 mHz to 75 MHz
HighZ
2 mVpp to 20 Vpp
2 mVpp to 10 Vpp
2 mVpp to 4 Vpp
key.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
DG922 Pro
1 μHz to 200 MHz
1 μHz to 60 MHz
1 μHz to 5 MHz
1 μHz to 50 MHz
1 μHz to 50 MHz
1 mHz to 100 MHz
Load (50 Ω)
1 mVpp to 10 Vpp
1 mVpp to 5 Vpp
1 mVpp to 2 Vpp
Figure 5.1
), click or tap the "Wave Type"
Figure 5.1
), click or tap the "Waveform