Source[<N>]]:Pwm:state - Rigol DG800 Pro Series Programming Manual

Command System
-
• When [:SOURce[<n>]] or [<n>] is omitted, it is interpreted as CH1.
Return Format
The query returns INT or EXT.
Examples
:SOURce1:PWM:SOURce EXTernal/*Sets the PWM modulation source to
external modulation source for CH1.*/
:SOURce1:PWM:SOURce? /*Queries the PWM modulation source for CH1.
The query returns EXT.*/
3.11.15.6 [:SOURce[<n>]]:PWM:STATe
Syntax
[:SOURce[<
[:SOURce[<
Description
Sets or queries the on/off status of the PWM modulation function for the specified
channel.
Parameter
Name
<n>
<bool>
Remarks
• The carrier waveform of PWM can only be Pulse. Only when the current
waveform is set to Pulse for the specified channel, can you enable the PWM
function. Different settings of pulse parameters (e.g. frequency, amplitude,
offset, pulse width, duty cycle) can affect the PWM modulated waveform.
• If the Sweep (
[:SOURce[<n>]]:BURSt:STATe
(
[:SOURce[<n>]]:FUNCtion:SEQuence[:STATe]
(
will be disabled automatically when the modulation function is enabled.
• When [:SOURce[<n>]] or [<n>] is omitted, it is interpreted as CH1.
DG800 Pro/DG900 Pro Programming
Guide
144
EXTernal: external modulation source. When the external modulation
source is selected, the generator receives the external modulating signal
from the rear-panel [AUX IN/OUT] connector.
n >]]:PWM:STATe < bool >
n >]]:PWM:STATe?
Type
Discrete
Bool
[:SOURce[<n>]]:SWEep:STATe
Range
{1|2}
{0|1|OFF|ON}
), Burst
), or Sequence
) function is currently enabled, it
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Default
1
0|OFF