Source[<N>]]:Sweep; Source[<N>]]:Sweep:htime:start - Rigol DG800 Pro Series Programming Manual

Remarks
• Waveform summing function is to sum the specified waveform on the basic
waveform like Sine, Square, Ramp, and Arb (except DC) and then output the
summed waveform.
• If the Sweep (
[:SOURce[<n>]]:BURSt:STATe
(
[:SOURce[<n>]]:FUNCtion:SEQuence[:STATe]
(
will be disabled automatically when the waveform summing function is
enabled.
• When [:SOURce[<n>]] or [<n>] is omitted, it is interpreted as CH1.
Return Format
The query returns 0 or 1.
Examples
:SOURce1:SUM:STATe ON /*Enables the waveform summing function for
CH1.*/
:SOURce1:SUM:STATe? /*Queries the on/off status of the waveform
summing function for CH1. The query returns 1.*/
3.11.17 [:SOURce[<n>]]:SWEep
[:SOURce[<n>]]:SWEep are used to set and query sweep parameters including start
hold time, stop hold time, return time, sweep type, number of steps, sweep time, and
the on/off status of the sweep function.
3.11.17.1 [:SOURce[<n>]]:SWEep:HTIMe:STARt
Syntax
[:SOURce[<
[:SOURce[<
Description
Sets or queries the start hold time of the sweep function for the specified channel.
Parameter
Name
<n>
<time>
<lim_set>
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
[:SOURce[<n>]]:SWEep:STATe
), or Sequence
n >]]:SWEep:HTIMe:STARt {< time >|< lim_set >}
n >]]:SWEep:HTIMe:STARt? [< lim_query >]
Type Range
Discrete {1|2}
Real 0 s to 3600 s
Discrete {MINimum|MAXimum|DEFault}
Command System
), Burst
) function is currently enabled, it
Default
1
0 s
-
DG800 Pro/DG900 Pro Programming
Guide
149