Table of Contents
Advertisement
interface is displayed. You can set the remote terminal address. For details, refer
to descriptions in
•
RTA+11Bit: triggers on the RTA and the remaining 11 bits.
After this trigger condition is selected:
-
-
•
Error: triggers on the specified error type. After this trigger condition is selected,
click or tap the drop-down button of Err Type to select the error type.
-
-
Trigger Mode
In Sweep, select Auto, Normal, or Single as the trigger mode. For details, refer to
Trigger Mode
Trigger Parameter Setting
You can refer to
8.8
Trigger Output Connector
The rear-panel trigger output connector ([AUX OUT]) of this series can output trigger
signals determined by the current setting (hardware trigger).
Click or tap
signal which reflects the current oscilloscope capture rate can be output from [AUX
OUT] connector each time a trigger is generated by the oscilloscope. If this signal is
connected to a waveform display device to measure the frequency, the measurement
result is the same as the current capture rate.
If "PassFail" is selected in Aux Out, the instrument can output a pulse from the [AUX
OUT] connector when a pass/failed event is detected during the pass/fail test.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
I2C Trigger
Click or tap the input field of RTA, and then the "Format" interface is
displayed. You can set the remote terminal address. For details, refer to
descriptions in
I2C Trigger
Click or tap the input field of Bit time, and then the "Format" interface is
displayed. You can set the bit time position value to 0 (low), 1 (high), or X
(don't care). For details, refer to descriptions in
Sync Error: triggers when an invalid sync pulse is found.
Check Error: triggers when the parity bit is incorrect for the data in the
word.
.
Noise Rejection
to set the noise rejection under this trigger type.
> Utility. Click or tap Setup, and then select "TrigOut" in Aux Out. A
.
.
I2C Trigger
Triggering the Oscilloscope
.
HDO4000 User Guide
127
Advertisement
Table of Contents
