Output[<N>]:Trigger - Rigol DG800 Pro Series Programming Manual

Command System
Parameter
Name
<n>
<port>
Remarks
• FRONt: front port. When the output of CH1/CH2 sync signal is enabled, the sync
signal is output from the front-panel [CH2]/[CH1] connector. In this case, the
front port for sync signal output cannot be configured.
• BACK: rear port. When the sync signal output is enabled, it is output from the
rear-panel [AUX IN/OUT] connector.
TIP
As DG821 Pro has only one channel, it only supports rear-port sync signal output (unless the
two-channel upgrade option is installed).
Return Format
The query returns FRON or BACK.
Examples
:OUTPut1:SYNC:SOURce FRONt /*Sets the sync signal output port to
front port for CH1.*/
:OUTPut1:SYNC:SOURce? /*Queries the sync signal output port for
CH1. The query returns FRON.*/
3.10.9 :OUTPut[<n>]:TRIGger
Syntax
:OUTPut[<
:OUTPut[<
Description
Sets or queries whether the trigger output is enabled for Sweep or Burst mode.
Parameter
Name
<n>
<bool>
DG800 Pro/DG900 Pro Programming
Guide
60
Type
Discrete
Discrete
n >]:TRIGger < bool >
n >]:TRIGger?
Type
Discrete
Bool
Range
{1|2}
{BACK|FRONt}
Range
{1|2}
{0|1|OFF|ON}
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Default
1
BACK
Default
1
0|OFF