Source[<N>]]:Burst:mode - Rigol DG800 Pro Series Programming Manual

Command System
• For the relations among the burst period, basic waveform period, and burst
count, the following formula should be satisfied:
Burst Period ≥ ⌈(Burst Count x Waveform Period) ÷ 6.4 ns⌉ x 6.4 ns + 4 μs
• If the burst period is too short, the generator will increase it automatically to
ensure the output of the specified number of cycles.
• When [:SOURce[<n>]] or [<n>] is omitted, it is interpreted as CH1.
NOTE
[1]: ⌈x⌉ indicates that x is rounded up.
Return Format
The query returns the burst period in scientific notation. For example, the query
might return +1.000000000000000E-01, indicating that the period is 0.1 s.
Examples
:SOURce1:BURSt:INTernal:PERiod 0.1 /*Sets the burst period of
internally-triggered N-Cycle bursts to 0.1 s for CH1.*/
:SOURce1:BURSt:INTernal:PERiod? /*Queries the burst period of
internally-triggered N-Cycle bursts for CH1. The query returns
+1.000000000000000E-01.*/
3.11.4.3 [:SOURce[<n>]]:BURSt:MODE
Syntax
[:SOURce[<
[:SOURce[<
Description
Sets or queries the burst type for the specified channel.
Parameter
Name
<n>
<mode>
Remarks
• When the output mode of the specified channel is set to Burst, you can use this
command to set the burst type.
-
DG800 Pro/DG900 Pro Programming
Guide
82
n >]]:BURSt:MODE < mode >
n >]]:BURSt:MODE?
Type
Discrete
Discrete
TRIGgered: N-Cycle burst. The generator outputs a waveform with the
specified number of cycles (burst count) when it receives the trigger signal.
[:SOURce[<n>]]:BURSt:NCYCles
You can use
Range
{1|2}
{TRIGgered|GATed}
to set the burst count.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
[1]
Default
1
TRIGgered