Build Pause Warnings - Stratasys K6 Series User Manual

BUILD PAUSE WARNINGS

Note: For all pause related warnings, attempt to resume the build (by pressing
the Build (play) button within the Build page) prior to performing the step(s) for
correcting the pause condition.
Out of model material
• The printer has run out of model material. If 2 model material canisters are installed, this warning
indicates that both canisters are empty.
•
Correct condition - remove the empty canister(s) and replace as needed. See
canister" on page 125
Out of support material
•
The printer has run out of support material. If 2 support material canisters are installed, this warning
indicates that both canisters are empty.
• Correct condition - remove the empty canister(s) and replace as needed. See
canister" on page 125
Model canister removed during build
• Indicates that the printer lost contact with the canister's memory chip or the canister drive
inadvertently lifted.
• Correct condition - ensure that the canister is seated correctly within the canister drive. If so, remove
the canister and then reinstall it (see
on page 120). If this does not correct the error, remove the canister and install a new canister.
Support canister removed during build
•
Indicates that the printer lost contact with the canister's memory chip or the canister drive
inadvertently lifted.
• Correct condition - ensure that the canister is seated correctly within the canister drive. If so, remove
the canister and then reinstall it (see
on page 120). If this does not correct the error, remove the canister and install a new canister.
Detected end of model filament
• Indicates that the canister may have run out of model material (is empty) or filament may have
broken within the filament tubes.
• Correct condition - remove the empty canister(s) and replace as needed. See
canister" on page 125
Detected end of support filament
•
Indicates that the canister may have run out of support material (is empty) or filament may have
broken within the filament tubes.
• Correct condition - remove the empty canister(s) and replace as needed. See
canister" on page 125
and "Canister Installation" on page 120
and "Canister Installation" on page 120
"Removing Canisters" on page 125
"Removing Canisters" on page 125
and "Canister Installation" on page 120
and "Canister Installation" on page 120
249
"Removing an empty
for instructions.
"Removing an empty
for instructions.
and "Canister Installation"
and "Canister Installation"
"Removing an empty
for instructions.
"Removing an empty
for instructions.