Table of Contents
Advertisement
Insert a build sheet
•
Indicates that a build sheet has not been placed onto the platen.
Note: Once a build sheet has been placed onto the platen this warning will be
displayed until the printer achieves sufficient vacuum to securely affix the build
sheet to the platen. The red X over the top of the Vacuum Status Indicator (within
the Information Bar) will disappear once sufficient vacuum is achieved.
•
Correct condition - open the oven door and place a build sheet onto the platen (see
on page 166
for more information).
•
If a build sheet has already been placed onto the platen but sufficient vacuum hasn't been
achieved, this is often the result of a poorly positioned build sheet. Ensure that the platen is free
of material debris and then reposition the build sheet on the platen. Wait for the printer to achieve
sufficient vacuum. If you are still unable to achieve sufficient vacuum, install a new build sheet.
Contact Stratasys Customer Support or your regional Stratasys office if after performing these
steps you are still unable to achieve sufficient vacuum (see
contact information).
Check dryer system
•
Dry air pressure is below minimum requirement for printer operation.
•
Correct condition - contact Stratasys Customer Support or your regional Stratasys office (see
"Getting Help" on page 242
Tip sensor error
•
The tip sensor is sensing the tip when it should not be.
•
Correct condition - contact Stratasys Customer Support or your regional Stratasys office (see
"Getting Help" on page 242
Rear head fan is not operating.
System still operable with some materials.
•
Indicates that the printer's software detects a high-performance head but the rear head fan is not
running (i.e. not spinning at all or installed incorrectly). Can be displayed at system start-up or prior to
starting a build.
•
Displayed as a warning for users, no change in normal printer operation.
Rear head fan is not operating or not installed.
System is not operable with current material.
System still operable with some materials.
•
Displayed at system start-up. Indicates that the rear head fan RPM is outside the allowable range for
the currently installed material (RPM allowable range is determined by the currently installed
material). Some materials do not require the rear head fan to be running for proper printer operation.
•
Correct condition - printer is still operable with some materials, but not the currently installed
material. Change material type (see
Rear head fan is not operating.
System is not operable with current material.
System still operable with some materials.
•
Displayed when the printer is idle. indicates that the rear head fan RPM is outside the allowable
range for the currently installed material (RPM allowable range is determined by the currently
installed material). Some materials do not require the rear head fan to be running for proper printer
operation.
•
Correct condition - printer is still operable with some materials, but not the currently installed
material. Change material type (see
instructions).
for contact information).
for contact information).
"Changing Tips or Material Type" on page 128
"Changing Tips or Material Type" on page 128
246
"Before a Build"
"Getting Help" on page 242
for instructions).
for
for
Advertisement
Table of Contents
