Table of Contents
Advertisement
18.
The Adjust XYZ Calibration page will open; this page will vary slightly depending on the type of
units that the printer is configured for (see
within this page will allow you to make XYZ tip offset adjustments based on an analysis of the
calibration part. The Material Thickness field displays the slice height for the model tip installed in
the printer. The information within
analyzing the calibration part and making XYZ tip offset corrections, if needed (see
Offset Calibration" on page 192
Adjust XYZ Calibration page - English units
19.
Determine the XY Offset Adjustment needed for your printer.
A.
Using a magnifier (included in the Welcome Kit), view the relationship between the support
calibration toolpath and the alignment indicators to determine the X and Y axis calibration.
•
Holding the build sheet up to the light, a contrasting-colored wall, or a contrasting-colored piece
of paper may make it easier to view this toolpath.
"Units" on page 88
step 19
and
step 20
for additional information).
152
for details). The icons and buttons
will guide you through the process of
Adjust XYZ Calibration page - Metric units
"XYZ Tip
Advertisement
Table of Contents
