Stratasys K6 Series User Manual page 169

• The Build Calibration Part screen will be displayed (see
begin building. A two-part radial progress graphic displays time remaining for the build as well as
the build's percentage of completion. Once the calibration part is complete you will be prompted
to remove the part from the printer (see
the Next button.
• Repeat the instructions in
layer matches the model tip slice height ±0.0005 in. (0.01 mm).
21. Once you're finished adjusting for XYZ offsets, press the Next button to proceed with the wizard.
A screen will be displayed momentarily and your calibration adjustment(s) will be saved.
22. Once calibration is complete, a screen similar to the following is displayed. From this screen you
have the option of:
• Exiting the wizard by pressing the X (Cancel) button. Upon exiting the wizard, your printer's
materials/tips configuration information will reflect the changes made throughout the wizard.
• Proceeding directly to the Tip Wipe Adjust Wizard by pressing the Next button. It is
recommended that you proceed to the wizard and immediately adjust tip wipe height, for both the
model and support tip, as improper tip height can significantly impact part quality. See
Tip Wipe Heights" on page 164
XYZ Tip Offset
Calibration button
(for rebuilding a
calibration part)
step 17
step 20. Continue to check and adjust for Z offset until the support
for detailed instructions.
Cancel button for exiting the Tip Change Wizard
160
step 17 B.) and the calibration part will
C.). Remove the completed part and then press
"Adjusting
Next button for
proceeding to
the Tip Wipe
Adjust Wizard